Site map+98 21 2201 8011Contact us
Steel industry catalysts

ICD-300 Inert Catalyst

Inert catalyst for the bottom layer of the reformer tubes in direct-reduction plants.

Inert Catalyst

Where it is used

The process steps where this product is used are highlighted.

Direct reduction of iron units

In the reformer of a direct-reduction plant, natural gas and recycled top gas from the furnace are turned into reducing gas, which reduces iron ore pellets to sponge iron.

  1. FeedNatural gas and recycled top gas from the reduction furnace
  2. Feed gas desulfurizationThe zinc-oxide (ZnO) adsorbent takes up the sulfur compounds in the feed gas before it enters the reformer, so that the reformer catalyst is not poisoned.
  3. ReformerThe reformer tubes are filled from bottom to top with layers of inert, semi-active and active catalyst; ICD-120 and ICD-130 are for PERED plants.
  4. OutputReducing gas (hydrogen and carbon monoxide) for the reduction furnace
The order of steps and the catalyst positions are a draft awaiting approval by the technical department.Industry page →

Specifications

ShapeCylinder
ColourWhite
Outer diameter28–36 mm
Height or length28–35 mm
Hole diameter14–19 mm
Number of holes1
Bulk density1.30–1.5 kg/L
Radial crush strength> 250 N/pellet
Pore volume< 0.03 cm³/g
Al₂O₃Balance wt%
CaO + K₂O< 1.5 wt%
MgO< 0.5 wt%
TiO₂< 2.2 wt%
Packaging50 plastic bags of 5 kg in a moisture-proof 220 L drum
StorageKeep dry
Typical service life5 years

These values are awaiting final approval by the technical department; ask us for the official data sheet.

The technical and safety data sheets of this product are sent on request. Request the technical or safety data sheet

Talk to our engineers about the right catalyst for your unit.